For use in neuromonitoring procedures in conjunction with
electrodes.Use a bell shaped cup electrode with the hole in the
center.Apply just enough paste inside of the EEG electrode to very
slightly overfill the cup. Place the electrode onto the electrode
site and press with medium pressure. A small amount of paste may
come out the hole.Pressing too hard will cause all of the paste to
come out and electrode will not adhere well. Clean with warm water.
Our EEG paste contains the right balance of adhesiveness and
conductivity, enabling the electrodes to remain in place while
allowing the transmittance of electrical signals.
2, Washable and non-drying
3, Easy clean up
4, Water soluble, non-staining, non-gritty
5, Fast reduce Impedance
6, Applied with EEG Caps
8, Available in 2 sizes: 500g / 1000g